Published 20 November 2026 at 14:57
Many of us have stood with a temperature logger in hand, wondering where to place it. Inside a freezer room the battery performs worse and the logger is hard to reach. Outside, it shows the wrong temperature. Measuring in a heating container, a cramped machine cabinet or an oven is even trickier. The measurement then often ends up in the wrong place, and the data doesn’t tell you what you need to know.
The electronics in one place, the probe in another
The TandD TR42A is a Bluetooth logger with an external thermistor probe on a cable. The logger is placed where it is protected and easy to access. The probe is placed where the temperature actually needs to be measured. The standard TR-5106 probe is included, and it can be replaced with other TandD probes, for example a water-resistant version or one for higher temperatures. Depending on the probe, the measuring range covers -60 to +155 °C.
Accuracy is ±0.3 °C between -20 and +80 °C, and the response time is approximately 80 seconds in air and approximately 7 seconds in stirred water. The logger holds 16,000 readings with fifteen fixed intervals from 1 second to 60 minutes. The battery, an LS14250 cell, lasts about a year. Data is read out via Bluetooth to the T&D Thermo app, and a full memory is downloaded in about 15 seconds. No separate receiver is needed, and no PC installation on site.
Three situations where it comes in handy
Food production and commercial kitchens. Cold rooms and freezer rooms must be documented, but opening the door for every reading is rarely pleasant. With the probe routed through the door gasket or a cable gland, the logger hangs outside. You walk by, read it out via your phone and see the entire curve, including any temperature rise during the night.
Maintenance and workshop. When a process or hydraulic unit is suspected of running hot, you want a measuring point, not a guess. The probe can be attached where the heat is generated while the logger sits in a cool spot. You can compare curves before and after a corrective action.
Laboratory and quality. When checking ovens, heating cabinets or refrigerators, rather than just the room air, an external probe shows what the sample or product is exposed to. With a water-resistant probe, such as the TR-5530 with a 3-meter cable, you can measure directly in liquid. Note that the standard probe is not water-resistant, and that the IP64 protection applies to the logger unit.
Why it pays off
Manual readout rounds cost working time, and they only provide isolated values. What usually matters is what happened between two readings. A logger shows when the temperature left the limit value and for how long. This makes it easier to determine whether a product can be used or must be discarded, and how a deviation should be addressed. A single lost freezer load or a rejected delivery often costs more than the logger itself. And since the probes are replaceable, the same logger can be adapted to new measuring tasks.
Next step
If you need to measure temperature in places that are cramped, cold or hot, and want to read it out without disturbing the process, the TR42A is a practical choice. See the specification and probe options here.