Published 8 July 2026 at 14:54
The front shelf in the restaurant’s cold room is supposed to hold steady at +2 °C. The logger shows a graph that looks like an ECG: up to +11 every time a supplier opens the door, back down to +2 ten minutes later. Alarms go off. The HACCP record looks bad. The truth is that the products were never above +4 °C. It’s the air that spikes, and the sensor is measuring the air, not the product. A thermal buffer mount solves exactly this.
What it actually is
The 56-TB-3040SI is an aluminium block with a hole drilled in the middle. The sensor (TandD RTR505B, THA-3151, or a comparable probe with a Ø6 mm tip) slides into the hole. The aluminium block is mounted on the wall or shelf inside the refrigerated or frozen space. It may sound underwhelming, and that is the whole point. The mount’s only job is to be thermally massive.
When the air temperature spikes from +2 to +11 °C over 90 seconds (door opening, goods being put in, customers stirring up the air), that air heats the small aluminium block so little that the block’s temperature may rise only 0.3 °C. The sensor inside the block measures the block’s temperature, not the air’s. The curve becomes steady and smooth, representative of the products’ actual temperature. The HACCP documentation looks right. The alarms stop sounding needlessly.
When it makes a real difference
- Restaurants, commercial kitchens, catering — the door is opened 20-100 times per day.
- Pharmaceutical refrigerators (2-8 °C) — GDP/GxP documentation requires a stable curve, without air spikes causing formal deviations.
- Vaccine refrigerators — same thing. The regulatory frameworks are strict.
- Freezer rooms for fish, meat, ice cream — where product temperature is what counts, not air temperature swings.
- Wine cellars — the buffer mount ensures that brief disturbances from weather or ventilation don’t affect long-term curves.
- Retail refrigerators for sensitive goods — dairy shelves, deli refrigerators. Regulatory requirements apply to HACCP documentation.
Practical installation — checklist
- Choose the right position. The mount should sit where the products sit: not in the airflow from a fan, not near the door, and not directly below the condenser outlet.
- Slide the sensor tip (Ø6 mm) into the drilled hole. No thermal paste is needed, as the fit is tight.
- Screw or glue the block onto the shelf or wall. Weight is ~50 g per block.
- Note the logger’s timestamp for the ”buffer mount installation”. The curve changes immediately, and the HACCP auditor should be able to see the reason.
- Verify after one week: door spikes that previously reached +9-11 °C should now be dampened to +2.5-3.5 °C at most, with a time constant of 5-10 min instead of 30 seconds.
Why a 10-pack
A larger restaurant typically has 5-8 refrigerator/freezer points to monitor. A pharmaceutical warehouse may have 10-30. A 10-pack is enough for a reasonably mid-sized system, with spares for replacement if a mount gets dirty or damaged. Split from a pack, a single mount costs ~SEK 380, which is less than the investigation time a single false HACCP-documented deviation would cost.
SEK 3,820 for the 10-pack. The price is at instrument-accessory level, while the effect on data quality is fundamentally transformed.
Read more: TandD thermal buffer mount 56-TB-3040SI in the shop →